- 8 -
11.
Source mode switch
Notes:
The control panel is divided into two sections. Above the line, it is for the control of refrigerating drawers;
below the line, it is for the control of audio display. These two sections share the same digital display. The
numeral besides the “LEFT DRAWER” shows the temperature of the left drawer, and the numeral besides
the “RIGHT DRAWER” shows the temperature of the right drawer.
When setting the audio function, there is no temperature display, but the display of current audio operation.
Press the refrigerating drawer unlock button for 3 seconds, the refrigerating section is unlocked; press the
audio unlock button for 3 seconds, the audio display section is unlocked. These two sections are
independent from each other. The audio can be activated or closed independently.
Operation for the refrigerating section
1.
After powering on for the first time, the refrigerating section will enter the ECO intelligent mode
automatically. The buttons are in the non-locking state and they will enter into the locked state after 10
seconds without any operation.
2.
In the locked state, press the refrigerating drawer unlock button for 3 seconds, then you can touch other
buttons of this zone for operation.
Note: when the unlock button is pressed for more than 15 seconds, it will be regarded as mis-operation. The
appliance will not respond to this operation. Please remove the finger instantly and then you can operate again.
3.
To set the right drawer, touch the button “RIGHT DRAWER” after unlo
cking, the current drawer temperature
will flash, meaning that you can operate it. Each time you touch the button, the temperature will rise and
cycle as 5
→
6
→
…
→
11
→
12
→
OF
→
1
→
2
→
3
→
4 (
℃
)
( “OF” means closing the refrigeration of the
right drawer). If there is no operation for more than 3 seconds, the setting will be confirmed and the display
will stop flashing.
4.
The setting method of the left drawer can be referred to that of the right drawer.
5.
When the refrigerating section is unlocked, press the intelligent mode button for 3 seconds until the digital
display shows “ECO”
, then it will flash with the temperature of the left and right drawers. If there is no
operation for more than 2 seconds, the default will be confirmed and the display will stop flashing.
6.
When you open the drawer, the display shows the current temperature of the drawer. If the drawer door
keeps opening too long or it’s not closed very tight, the buzzer will alarm at intervals and the corresponding
drawer’s temperature display will turn to a flashing “dr” to remind you to close the door in time.
Notes for storing food:
The refrigerating drawers are used to store fresh food.
Do not store foods which are easily addled at low temperature, such as bananas, cut tropical fruits.
Excessive cooling will make the food discolored and its vitamin reduced.
Do not put hot food into the refrigerating drawer, for it will increase the temperature inside and affect the
freshness of other foods.
Do not open the drawer frequently. When the drawer is open, the hot air will come into the drawer and
cause the rising of the inside temperature.
Please use plastic wrap or bag to seal the food containers, or use a covered container to store food, in order
to avoid the evaporation of food moisture and retain the flavor and nutrition of food. It can also reduce the
smell inside the drawer.
Food such as vegetables and fruits should be washed and scrubbed clean before put into the drawer.
The bottles should be tightly placed to prevent them from tilting when opening the drawer.
The partitions in the drawer are used to separate the different types of food. Adjust the partitions according
to your needs. Please remove the partitions if the food volume is too large.
The sliding tray in the drawer can be used to store washed fruit (e.g. grapes/strawberries).
The temperature of the left and right drawer can be controlled independently. Adjust the temperature
according to the food characteristics.
Audio operation function
1.
After powering on for the first time, the audio is off. To turn on it, please keep pressing the audio unlock
button
“
”
for 3 seconds to activate the function.
2.
The buzzer sounds and the white aperture flashes, it means the audio is on, and the digital display shows
