Air Valve Check
Always check the air valve carefully before inflation to ensure there is not an air leak.
If the air valve is loose, use the provided wrench to fasten the air valve following
these steps:
With one hand, hold the backside of the air valve from the
inner side of the spa wall and turn the wrench clockwise.
NOTE:
1. Do not over tighten.
2. Do not adjust the air valve connector when the spa is in use.
treatment chemicals used in the spa.
• Empty the spa before remove it from the chamber or building.
2.Outdoor Installation
• Consult your local professional installers for environmental
conditions, such as ground water and risk of frost.
• Do not use the spa when ambient temperature is lower than
-10ºC(14°F)we strongly recommend the spa is disassembled during
the winter months to prevent damage, such as from water freezing
in the pipes and the circulation system. Piping subject to damage by
freezing shall have a uniform slope in one direction and shall be
equipped with valves for drainage or shall be capable of being
evacuated to remove the water.
• Recommended to protecting the spa from direct sunlight exposure
by a cover when not in use.
NOTE:
Only the Hydro-Jet Pro spa has the Lay-Z-Massage system
button. When inflating, you will notice that air will be expelled from the
area where the air hose connects to the pump, this is normal and
prevents damage due to over-inflation.
NOTE:
Do not use an air compressor to inflate the pool.
NOTE:
Do not drag the pool on rough ground as this may cause
damage to the pool liner.
NOTE:
Inflation time is for reference only.
303021213751_14x21cm_54138;54173_
⅝㿺
HydroJet SPA
䈪᱄Ҝ
_
㤧
13
