1. Switch off the sand filter and set the Control Valve to the Closed
function.
2. Replace the Debris Screens with Stopper Plugs to prevent water from
escaping.
3. Remove the Strainer Cover by unscrewing it.
4. Take out the Strainer, remove any debris.
5. Put the Strainer back into position. Ensure the hole in the strainer is
aligned.
6. Ensure the Seal Ring is in place. Secure the Strainer Cover back.
7. Remove the Stopper Plugs and insert the Debris Screens.
NOTE:
The Strainer must be emptied and cleaned periodically.
A dirty or blocked strainer will reduce the performance of the sand filter.
1. Switch off the sand filter and set Control Valve to the Drain function.
2. Detach the Hose from the pool’s Port A and sand filter Port A and
attach to Port D.
NOTE:
Remember to replace the Debris Screen with Stopper
Plug to prevent water from escaping.
3. Switch on the sand filter and press the “RESET” button to run the filter
and remove the pool water.
WARNING:
DO NOT DRY RUN THE SAND
FILTER.
13
CLEANING THE STRAINER
STORAGE
LOWERING OR DRAINING POOL WATER
In areas that have freezing winter temperatures, pool equipment must be
winterized to protect against damage. Allowing water to freeze will
damage the sand filter and void warranty.
1. Backwash the sand filter.
2. Drain the pool according to the pool owner’s manual.
3. Disconnect the two Hoses from the pool and the sand filter.
4. Completely pour the sand out of the tank and dry all components.
5. Store the sand filter in a dry location out of child’s reach.
