Congratulations on the purchase of your new Lay-Z-Spa™.
Before operating the Lay-Z-Spa™ be sure to follow these 14
steps. Damage resulting from misuse is not covered by the
manufacturer's warranty.
™
1
The Comfortable, Affordable, Go-Anywhere Spa!
™
1
The Lay-Z-Spa™ should not
be setup or left out in
temperatures lower than
4˚C (40˚F).
Fill the water level between
maximum and minimum
printed on the SPA wall.
Water
Level
MAX
MIN
3
Remove Stopper Caps
Ensure water is circulating between
the Spa and the Pump and that the
Stopper Caps have been
removed.
4
Check and ensure the Spa and
adapters are not leaking.
6
If the pump not heating properly,
please press the thermal cut-out
manual “Reset” button on
the pump.
9
Hibernate Function:
After 72 hours of
operation (except timer
function),
the pump will hibernate and “END”
will be display on the LED. When the pump is
hibernating both the rapid heating and water
filtration functions are disabled. To re-active
the pump simply press any button on the
control panel.
11
The PRCD must be tested before
each use.
2
10
All Spas require the use
of chemicals in order to
keep the water clear and
safe.
Change the Filter Cartridges
regularly
8
Clean and maintain the Filter
Cartridge regularly.
7
Be sure to set your desired
temperature.
5
RESET
TEST
IMPORTANT NOTICE:
This unit will auto lockout after
5 minutes of inactivity.
To simply place a finger
over function button
for 3 seconds.
12
We recommend you take a shower
before using your Lay-Z-Spa, as
cosmetic products, lotions, and other
residues on the skin can quickly
degrade water quality.
13
14
303021185651
303021185651/28.5x21cm/54112GB,54113GB,54123GB,54129GB,54148GB,54154GB,54171GB,54174GB,54175GB,54183GB,54186GB,54189GB/
英规
SPA
快速操作
14
步骤说明书插页
/JS-YF-2017-B-05209/
英
