1
2
3
It is important to follow these suggestions if you are setting up the spa during the winter
period. This will prevent damage to the PVC material and extend the life of your product
drastically.
• If the ambient temperature is below 10°C(50°F), we suggest keeping the package
indoor where the temperature is above 15°C(59°F) for at least 2h before inflation. This
will make the spa liner more flexible and easier to set up.
• Open the package in the same room where the temperature is above 15°C(59°F), and
inflate the spa using the spa heater.
• Position the spa liner outdoor in the desired position, connect the spa heater and fill
with water.
Important:
The water temperature used to fill the spa must be above 6°C(42.8°F),
otherwise when you begin to operate with the spa heater, the E03 alarm will appear.
Important:
If the Freeze Shield™ system isn’t working, alarms will pop up on the spa.
Be sure to check the status of your spa if the outdoor temperature is below 6°C(42.8°F).
In case of a long-term absence from home when there is a risk of temperatures falling
below 6°C(42.8°F), we strongly suggest disassembling the spa and storing it following
the storage procedure. When you assemble the spa, the automatic warm function will
turn on. In this condition, the spa can be used when the temperature is lower than
6°C(42.8°F).
Water Maintenance
Many pollutants in the water settle on surfaces below the water line. These
pollutants can cause bacterial, algal or fungal growth. It is recommended that spas
are cleaned as regularly as necessary. After a time, tenacious stains or biofilms may
develop on the accessible surfaces below the water line or high concentrations of
salts or unwanted reaction by-products may also occur. Depending on hygienic
condition, cleanliness, visibility, odour, debris and stains, it is recommended to
change the water completely and clean/disinfect the spa. When emptying the spa,
the regulations and the instructions for draining the water shall be observed.
Keeping your spa water clean and chemically balanced is necessary. Simply
cleaning the filter cartridge is not enough for proper maintenance, we recommend
you use pool chemicals to maintain water chemistry and chlorine or bromine tablets
(do not use granules) with the chemical dispenser.
Water quality will be directly related to frequency of use, number of users and
overall maintenance of the spa. The water should be changed every
3 days if there is no chemical treatment being performed with the water.
It is highly recommended to use tap water for spa filling to minimize the influence of
unwanted content, such as minerals. Barefoot areas and relaxing areas shall be
cleaned as well. No cleaning water may flow into the spa or spa water cycle. The
dirt and cleaning agents shall be rinsed carefully to drain in the spa surround.
Note:
We recommend you take a shower before using your Lay-Z-Spa, as cosmetic
products, lotions, and other residues on the skin can quickly degrade water
quality.To use the chemical dispenser, please follow the below instruction.
INSTALLATION
< 10°C(50°F)
>
15°C(59°F)
>
15°C(59°F)
SET-UP
INSTRUCTION
IN WINTER
8