8.
9.
9
OPERATIONS
1
Start
a set the right function and connect the right cable
b
check the output line and see if it is short circuit or loading is too low
c
check the local voltage is same as the require of power
d
adjust the volume to Min
e
connect the power supply, then open the sound source, pre and effect equipments,
must sure all equipments work well.
f
Open the power supply, and sure the indicator is lit up.
g
Adjust the volume to right place clockwise
2
Put off
a
adjust volume to Min. counter-clockwise
b
put off the power supply, and sure the indicator off
c
put off the pre and effect equipments and sound source equipment
PLEASE OBEY THE FOLLOWING:
3
Volume adjust
Connect the input signal and open the sound source, adjust the volume, if the indicator
is not lit up, please check the sound source. Adjust according to the voltage output and
the signal. When 0dB output voltage is lit up, the output is RMS, if is too much, will cause
the distortion.
4
Area setting
Six buttons and six yellow indicators, when the six indicators are lit up, it means that
there are output in six areas, press the area button, the relative area will be closed and
the indicators will be off.
BA Series Completed functions give the amplifier and speaker a good protection to avoid
the damage, like short circuit,overloading,and overheat.
1
Circuit protect:
2
Cverload protect:
3
Overheat protection:
If the unit will be back to required range, the nuit will be back to home.
PROTECTION FUNCTIONS
when exist the short circuit, it will be off automatically.
it will be off automatically when input impedance is too low.
if the temperature heat sink is over the standard degree.
/
/
