USE
Start / Stop
To start the pneumatic tool, press the start button (picture 2-b), and keep it pressed during the job to be performed. Releasing the
button will cause the pneumatic tool to stop quickly.
Check the position of the reverse lever (picture 4-d) before operating the pneumatic tool, so as to know the direction of rotation.
Setting direction of rotation
The pneumatic tool can rotate both clockwise and anticlockwise. Select the direction of rotation through the reverse lever (picture 4-d):
clockwise – seen from the operator’s side
anticlockwise - seen from the operator’s side
Use the reverse lever to select the direction of rotation and couple:
(F) selection
•
minimum screwing torque (approximately 1/3 of max. screwing torque)
(F) selection
•
•
medium screwing torque (approximately 2/3 of max. screwing torque)
(F) selection
•
•
•
maximum screwing torque
(R) selection
•
maximum unscrewing torque
Fit the required impact socket onto the male drive, and make sure that it is inserted correctly.
Always disconnect the air supply before fitting in tools or making adjustments; this precaution will prevent the pneumatic tool
from being accidentally started.
Lubrication/Greasing
The pneumatic tool must be connected to a filter-lubricator unit (we recommend Beta item 1919F1/4) provided with an air-oil microfog
mixer, set at two drops per minute. This will result in a high-performing tool and wear-resistant mechanical parts.
If lubrication is not provided to the line, oil ISO 32 must be periodically poured into the pneumatic tool, through the air supply hole
(picture 5-f)
.
Hammer face lubrication of Pin Clutch system in oil bath
Hammer face lubrication must be periodically checked (for flawless use, lubrication should be tested every 3 years). To check
lubrication, lay the impact wrench on a surface (picture 3c). Remove the hexagon socket headless screw and dispose of exhausted oil
(in an environmentally friendly way). Pour in motor oil (type SAE 15W40; amount = 20÷25 cc), remove excess oil, and tighten the
hexagon socket headless screw.
MAINTENANCE
Maintenance and repair jobs must be carried out by trained personnel. For such jobs, you can contact Beta Utensili S.P.A.'s repair
centre.
DISPOSAL
The pneumatic tool, accessories and packaging should be sent to a waste disposal centre, in accordance with the laws in force in your
country.
WARRANTY
This tool is manufactured and tested in accordance with current EU regulations, and is covered by a 12-month warranty for professional
use or a 24-month warranty for nonprofessional use.
We will repair any breakdowns caused by material or manufacturing defects by fixing the defective pieces or replacing them at our
discretion.
Should assistance be required once or several times during the warranty period, the expiry date of this warranty will remain unchanged.
This warranty will not cover defects due to wear, misuse or breakdowns caused by blows and/or falls. In addition, this warranty will no
longer be valid if any changes are made, or if the pneumatic tool is forced or sent to the customer service in pieces.
This warranty explicitly excludes any damage to people and/or things, whether direct or consequential.
DECLARATION OF CONFORMITY
We hereby declare, assuming full responsibility, that the described product complies with all the relevant provisions of Machine
Directive 2006/42/EC and amendments thereto, as well as with the following standard:
• EN ISO 11148-6
The Technical Brochure is available at:
BETA UTENSILI S.P.A.
Via A. Volta 18
20845 Sovico (MB)
ITALY
F
R
Libretto 1927B.qxd:Libretto 1927CD.qxd 19-09-2018 10:20 Pagina 10
