USE
Start / Stop
To start the polisher, press the trigger
(picture 1)
, and keep it pressed during the job to be performed. Releasing the trigger will cause
the pneumatic tool to stop quickly.
The polisher is fitted with a rear air outlet
(picture 4)
.
When the polisher stops, place it in a firm and safe position. The disc does not stop immediately.
Pad installation/replacement
Install the pad on the polisher
(picture 2)
as follows:
• Use the open end wrench to lock the rotation spindle and loosen the pad by hand
• Fit a new threaded pad onto the rotation spindle; lock the pad by hand, holding the rotation spindle with the open end wrench
• Make sure that the pad has been fixed correctly
• Place the polishing discs on the pad concentrically
• The polisher can rotate in one direction only, namely clockwise
.
Polisher speed regulation
Use the adjusting knob at the back of the polisher
(picture 3)
; adjust minimum or maximum speed
.
Always disconnect the air supply before making adjustments or fitting in the grinding wheel. This precaution will prevent the
pneumatic tool from being accidentally started.
Lubrication/Greasing
The pneumatic tool must be connected to a filter-lubricator unit (we recommend Beta item 1919F1/4) provided with an air-oil microfog
mixer, set at two drops per minute. This will result in a high-performing tool and wear-resistant mechanical parts.
If lubrication is not provided to the line, oil ISO 32 must be periodically poured into the pneumatic tool, through the air supply hole
(picture 4)
.
MAINTENANCE
Maintenance and repair jobs must be carried out by trained personnel only. For such jobs, you can contact Beta Utensili S.P.A.’s repair
centre through your Beta dealer.
DISPOSAL
The pneumatic tool, accessories and packaging should be sent to a waste disposal centre, in accordance with the laws in force in your
country.
WARRANTY
This tool is manufactured and tested in accordance with current EU regulations, and is covered by a 12-month warranty for professional
use or a 24-month warranty for nonprofessional use.
We will repair any breakdowns caused by material or manufacturing defects by fixing the defective pieces or replacing them at our
discretion.
Should assistance be required once or several times during the warranty period, the expiry date of this warranty will remain unchanged.
This warranty will not cover defects due to wear, misuse or breakdowns caused by blows and/or falls. In addition, this warranty will no
longer be valid if any changes are made, or if the pneumatic tool is forced or sent to the customer service in pieces.
This warranty explicitly excludes any damage to people and/or things, whether direct or consequential.
DECLARATION OF CONFORMITY
We hereby declare, assuming full responsibility, that the described product complies with all the relevant provisions of Machine
Directive 2006/42/EC and amendments thereto, as well as with the following standard:
• EN ISO 11148-8
The Technical Brochure is available at:
BETA UTENSILI S.P.A.
Via A. Volta 18 - 20845 Sovico (MB) - ITALY
Libretto 1937KL.qxd:Libretto 1937KL.qxd 6-09-2017 14:29 Pagina 10
