Bekamatic SC pg. 2
Table of Contents.
1.
Warnings
................................................................................................................................... 3
1.1.
Warnings for installer and end user
.................................................................................. 3
1.2.
Special points to note
............................................................................................................. 3
1.3.
Safety rules for end user
....................................................................................................... 5
2.
Guidelines for installation
.............................................................................................. 5
3.
Guidelines for gate lifting
................................................................................................ 6
4.
Foundations
............................................................................................................................. 6
4.1.
Gates opening to the right
............................................................................. 8
4.2.
Gates opening to the left
................................................................................. 9
5.
Preparations before gate installation:
.................................................................. 10
5.1.
Fixing requirements
................................................................................................. 10
5.2.
Installation of the ground anchors:
.............................................................. 10
5.3.
Preparing installation levels:
............................................................................. 11
6.
Installation of the gate onto the ground anchors:
........................................... 12
7.
Installation of the lock post onto the ground anchors:
........................................... 13
8.
Alignment and levelling of the gate:
.................................................................... 13
9.
Adjustment of the mechanical end stops:
.......................................................... 16
9.1.
Adjustment of the front mechanical end buffering:
............................. 16
9.2.
Adjustment of the rear mechanical end
buffer:
...................................... 17
10.
Motor height Adjustment:
............................................................................................. 18
11.
Set-up of the end position:
.......................................................................................... 20
12.
Power Supply:
...................................................................................................................... 20
13.
Adjustment and testing of safety equipment:
.................................................... 21
13.1.
Wireless transmission system for safety strip
........................................ 21
on the wing
......................................................................................................................................... 21
13.2.
Safety strips:
................................................................................................................ 23
13.3.
Photocells:
..................................................................................................................... 23
14.
Different Set-up systems:
................................................................................... 25
14.1.
Set-up for Bus-system:
......................................................................................... 25
14.2.
Start the Self-Learning procedure
.................................................................. 26
15. Maintenance:
............................................................................................................................. 27
16.
Revision:
.................................................................................................................................... 27
