[H ie
Bekamatic SC pg. 21
r eingeben]
[H ier eingeben]
[H ier eingeben]
2)
Switch the current on by turning the main switch
position to
“ON”.
WARNING:
THE CABLE DIAMETER CALCULATIONS ARE BASED ON OUR GATE WITH
ALL OUR POSSIBLE ACCESSORIES. IF YOU ARE CONNECTING MORE
CONSUMERS TO IT, IT MAY BE NECESSARY TO USE A BIGGER CROSS-
SECTION.
13.
Adjustment and testing of safety equipment:
13.1.
Wireless transmission system for safety strip
on the wing
•
The radio system simplifies the installation of safety edges in any
position (including complex ones) with no need for physical cable
connections between safety edges and the automation’s control
board.
•
The radio system comprises of an XRS 868 radio receiver able to
communicate with XTS 868 transmitters; one or two resistive safety
edges (8.2 k Ohm XS55) or auxiliary devices (N.C. contacts) which
can be connected to each transmitter input (No.2). Each radio
receiver XRS 868 can manage up to 6nr XT S 868 transmitters, i.e.
up to 12 safety edges mod. XS55 (8.2 k Ohm).
•
Cabling to FAAC control boards equipped with BUS 2easy is done
with just two non-polarized wires. The receiver communicates via
BUS-2 Easy on two dedicated addresses (opening protection and
closing protection), you do not need any other cabling to comply
with safety regulations. The terminal output "Transmitters Battery
level" is the only usable one.
Main switch
