Bekamatic SC pg. 5
1.3.
Safety rules for end user
-
Attention: In all cases once the gate has been installed and taken into
service the user is, from this point on responsible for his gate.
-
The user is responsible for the following:
•
That all safety related hazards are correctly controlled
(Photocell, Safety Strips).
•
Correct functioning.
•
Yearly maintenance.
•
Safety Inspection (dependent on country of use)
-
Under the safety and correct functioning of the gate it is understood that
the user checks on a regularly basis (minimum once a year) if all safety
devices and access control options are still working properly as they
should.
-
Under the yearly maintenance it is understood that the maintenance that
is described by the manufacturer has been followed. If a maintenance
contract between the customer and Betafence exists, Betafence will carry
of this maintenance in cooperation with the user.
-
For gates installed in Germany the user must ensure that every 12 months
the gate is inspected as per ASR A 1.7. Once inspected the testing agency
raises a report. If the gate meets all requirements, then this is indicated in
the report and a test sticker is applied to the gate. If the gate fails, then
the faults are captured in the report and communicated to the user. The
user is then responsible for the repairs and the re-submission of the gate
for re-inspection.
-
For older gates which have not been built according to DIN EN 13241-1,
the user is obligated legally to ensure that his gate meets all new
standards / regulations issued.
2.
Guidelines for installation
•
Only licensed technicians or installers who have had adequate
product training provided by Betafence should be permitted to install
the gate.
•
The integration of the gate into a fence must not create additional
dangers / hazards. Please read carefully the warning document and
consider the integration examples in the document package
delivered with the gate.
