![background image](http://html1.mh-extra.com/html/betafence/r2000/r2000_installation-manual_2742826026.webp)
26
Robusta SC
5.
Adjustment of the mechanical stops:
5.1. Adjustment of the front mechanical end buffering:
ATTENTION!
The verification and/or the adjustment of the mechanical end buffering must
always be executed. When the end buffering is not adjusted properly it may
cause severe irreversible damage to some parts of the gate.
The mechanical end buffering is located on the front- and rear support of the
guiding wheels in the under beam. To have access to them the front and the
rear of the under beam must be opened.
If the gate is installed correctly according the foundation plan, the
front end buffer doesn’t need to be adjusted as the factory
default setting of 60mm will be sufficient.
However, if there is some deviation from the
foundation plan or if an obstacle at the rear side of
the gate is preventing the wing opening over its full
length, then adjust according to the description
below:
1)
Remove the lower part of the safety pressure strip from its
aluminum fixation profile.
2)
Remove the front cover plate from the under beam by
unscrewing the 4 screws on the front of the underbeam.(two
on both sides).
Summary of Contents for R2000
