![background image](http://html1.mh-extra.com/html/betafence/r2000/r2000_installation-manual_2742826037.webp)
37
Robusta SC
- In the same time press now on the Programming button of your
receiver. The LED indicator goes on and after a view seconds flash
two times.
- now release the two buttons.
- Push the programmed button twice in quick succession.
The second push sets the gate in motion.
- If this happens the programming was successful.
9.4.2.
Programming a transmitter to another transmitter:
-
Using the programmed transmitter (function tested).
-
Push both buttons (2 to 3 secs.) until the LED on the top starts
to flash. Release both buttons. Transmitter is in programming
mode.
-
Take the transmitter which is to be programmed and hold it
together (head to head) with the
Master
transmitter which is
already in programming mode (see diagram below).
-
Push the programmed button on the Master and simultaneous
the button to be programmed on the second transmitter.
-
When the LED on the Master stays on, release both buttons.
-
Finally push the programmed button on the second transmitter
twice in quick succession. LED DL11 on the controller
illuminates.
-
If this happens the programming was successful
.
Summary of Contents for R2000
