10
Created 11.08.2014:
Approved 11.08.2014:
Bodo Kiesewalter
5.1.1 DIP-switch SETTINGS
Transmitter (component at the wing):
Switch 1: off
Switch 2: on
Switch 3: off
Receiver (component at the drive unit):
Switch 1 on
Switch 2: off
Switch 3: on
Switch 4: on
Switch 5: on
5.1.2 Programming the activation time
ATTENTION
:
First program the activation time, then program transmitters to the receiver
1. Press PROG button for 1.5 sec.
2. On hearing the acoustic signal stop pressing as the receiver will be logged into the
memorizing code process.
3. Prog. LED will be turned on indicating that you are programming transmitters.
4. Press PROG button again for 1.5 sec.
5. Prog. LED will flash indicating that you are programming power supply time.
6. Waiting time. You must wait for time you need for having the power supply for the OSE.
7. Press PROG button again for 1.5 sec. receiver will exit the process and power supply time
will be memorized.
IMPORTANT
:
times below 10 seconds will not memorize.
Table for activation times
5.1.3
Go in ‘advanced programming mode’ on motor controller and set FS and SA on ‘Y’