12
Created 11.08.2014:
Approved 11.08.2014:
Bodo Kiesewalter
IMPORTANT NOTE:
Replacing the optical resistance safety strip at the front of the wing by a resistance safety strip
is under responsibility of the installer. The present instruction guideline is given by Betafence
on an informative basis only.
6.2 Procedure to connect resistance safety strip to the AERF system
6.1 Transmitter:
The resistive safety strip has to connect to connector 1 and 2 of the transmitter.
The dip switch of the transmitter has to be changed to the follow position:
DIP 1: ON
DIP 2: OFF
DIP 3: OFF
The photo shows the wire of the
safety strip connected to the AERF
transmitter