13
Created 11.08.2014:
Approved 11.08.2014:
Bodo Kiesewalter
6.2 Receiver:
Two of the wire connections have to be changed.
The grey wire (connector 6) has changed to connector 3
The blue wire (connector 8) has changed to connector 5
The dip switch of the receiver has to be changed to the follow position:
DIP 1: ON
DIP 2: OFF
DIP 3: OFF
DIP 4: OFF
DIP 5: OFF
6.3 FAAC controller (Motor):
Open the programming menu, 2
nd
level. (F and + button)
The parameter “
FS”
has changed to “no”
If the Software is without the parameter “
FS
” nothing is to do
With these settings the AERF system stays always active (with low battery consumption).
The photo shows the wire (blue
and grey) connected to the new
position of AERF receiver
1
2
3
4
5
6
7
8
9
10 11 12