9
Created 11.08.2014:
Approved 11.08.2014:
Bodo Kiesewalter
Important, please note:
Without the plastic cap the working distance of the photocells are very low, about 2m only.
For to check it is required to assemble the plastic cap. A lens is inside the plastic cap for to
increase the range.
Connection plan of the photocells:
5. AERF System (Wireless Band)
AERF version 2.F.I
If the AERF system doesn’t work, please check the battery of the transmitter (In front of the wing)
at first. Change the FAAC drive unit to the manual mode and open the gate with hand.
Push the safety strip on top of the wing, the relay inside the receiver should work if the gate is
open. (Small distance between transmitter and receiver) If so, the batteries are empty and they
must exchange. Use batteries with a power of 3.6v only!! (
SAP code for battery 1017580
)
If the system doesn’t work, choose the DIP settings of transmitter and receiver as described in
point 5.2.
If the system is working, change back the DIP setting (point 5.1.1) and reprogram the system.
Attention
:
Before the reprogramming procedure push the button on the controller board of the receiver
(item on the FAAC drive unit) and hold on pushing till a triple beep comes. Release the button and
disconnect the connection plug of the receiver for 10 seconds. Reconnect it and follow point 5.1.2
5.1 Used with the drive unit 746/844 with firmware 1Q
This version is foreseen of a sticker: NEW VERSION 1Q, put on the transformer to the left of the
controller