l In the MAIN menu, select CONFIG, then CALI;
l Push the direction joystick to the right to enter level calibration mode. Quadcopter’s
LED flashes blue;
l When the OK prompt appears and the LED returns to solid blue, the calibration is
complet
e. Pilot
can exit the OSD menu.
Note: For more information about how to access and operate OSD menu, please refer to the
Chapter “OSD Menu Operation”.
Remote Control Radio Transmitter Calibration
After repeated use or if the remote control radio transmitter is subjected to physical impact, the
joysticks may no longer read correctly and require recalibration.
l After powering on, press the
SETUP
button on the back of the r
emote control radio
transmitte
r which will beep twice, and LED will fla
sh red twice quickly. The remote
control radio transmitter has entered calibration mode.
l Move throttle joystick and direction joystick to middle position. Press SETUP button again
and wait until the remote control radio transmitter
beeps three times. The red LED will
flash twice quickly. This indicates joysticks center data has been acquired.
l Slowly rotate the throttle and direction joystick twice around the boundary of the
joysticks(once counterclockwise and once clockwise), then press SETUP button again.
