6
5. 3 DSMX Protocol
Supports DSMX protocol. Here is the diagram with DSMX protocol receiver:
The communication protocol should be set as DSMX protocol when using DSMX
receiver, as follows:
Press the FC button on the bottom of the FC and plug the battery at the same
time
Release the button and press the FC button TWICE within 4 seconds
Once “DSMX” shown on OSD information interface, FC will receive the
external receiver data via DSMX protocol
6.OSD MENU
AETR is the default channel mapping of Lite brushed FC.
6.1 How to Enter OSD Menu
The method of entering OSD Menu on Lite Brushed FC is same as Betaflight. Make
sure the drone is disarmed when entering OSD Menu on Lite 1S Brushless FC.
-Use Mode 2 (American Mode) as example-
Note: The left throttle stick should be at the middle position and then pull left.
Note: AETR is the default channel mapping of Lite FC. If you can not enter the OSD
menu, it might cause by unmatched channel mapping.
Summary of Contents for Lite brushed V2 FC
Page 4: ...3 3 DIAGRAM...
