16
ORBITAL PADS AND ORBITAL FINISH REMOVAL
STANDARD CLEANING OPERATIONS
NOTE: Do NOT lower the Orbital Scrub Head without a pad attached. This will
damage the scrub head.
1. Attach the pad ½” in front of the scrub head and align the front corners and
sides. Press the pad into position once the pad is aligned (the ½” forwarding
will help in pad wetting).
2. Lower the scrub deck onto the floor once the pad is aligned.
3. Check to make sure the pad is aligned on all four sides.
ORBITAL FINISH REMOVAL PAD SETUP
This application utilizes a two-pad setup. A red or white pad acts as a “backer pad” that helps compensate for flaws and
variances in the floor. The maroon pad is for surface preparation.
1. Attach the red pad to the orbital pad drive plate as shown above.
2. Place the pad on the floor and position it so that when the scrub deck is lowered, the red and maroon pad aligned and
stacked.
MACHINE SETUP FOR ORBITAL FINISH REMOVAL
1. Install the pad assembly as described above.
2. Fill the solution tank with clean water.
3. The down pressure should be on medium or high pressure; depending on condition or hardness of the finish being removed.
4. The solution flow rate should be set to a low flow rate (approximately 25% of full flow rate) for this operation to maximize
finish removal, to rinse, clean the floor and pad.
5. Forward speed should be set to 25% to 50% of normal speed to ensure maximum finish removal ; approximately 50-100
feet per minute.
Summary of Contents for E27200
Page 25: ...25 ...
Page 28: ...28 SQUEEGEE DIAGRAM 9 15 14 12 19 8 5 16 7 10 1 3 4 20 2 18 11 13 15 9 17 10 6 6 ...
Page 51: ...51 ...
