23
45. THE MACHINE DOES NOT START
1. Check to ensure the batteries are connected to the machine (
1
).
2. Check that the key switch is turned on.
3. Check that the batteries are charged (
2
).
46. ELECTRICAL FUSES AND THERMAL CUT-OFF
In addition to standard 80 amp fuses, the machine is also fitted with self-restoring
thermal safety fuses located on the electrical boards. These will interrupt the
power supply to the brush drive motors and vacuum motor when the amp draw
exceeds a pre-determined limit. To restore power to the motors, switch off the
machine and wait about 1 minute for the thermal fuses to cool down. Contact a
certified repair center if the thermal switches disconnect again.
TROUBLESHOOTING GUIDE
POLYPROPYLENE BRUSH
Used on all types of floors. Good resistance to wear and hot temperatures (no greater than 140° F). The polypropylene brush is non-
hygroscopic and therefore retains it characteristics in wet working conditions.
NYLON BRUSH
Used on all types of floors. Excellent resistance to wear and hot temperatures (no greater than 140° F). The nylon brush is hygro-
scopic and tends to lose its characteristics over time when working in wet conditions.
ABRASIVE BRUSH
The bristles of this type of brush contain highly aggressive abrasives. It is used to clean very dirty floors. To avoid floor damage,
work only with the brush pressure that is necessary.
THICKNESS OF THE BRISTLES
Thicker bristles are more rigid and are therefore used on smooth floors or floors with very shallow joints. On uneven floors, or those
with deep joints, it is advised to use softer bristles which can flex to enter the joints more easily. Remember that when the bristles are
worn and too short, they will become more rigid and will no longer penetrate into the deep joints.
PAD DRIVER
The pad holder is recommended for cleaning shiny surfaces. There are two types of pad holder:
1. The traditional pad holder is fitted with a series of pad gripping points that hold the pad in place and drag the pad along as it works.
2. The center-lock pad holder not only has the gripping points, but also has a center locking device that hold the pad in place and
prevent it from becoming detached during use. The center lock style pad holder is recommended for all machines that use more
than one pad.
CHOOSING AND USING THE BRUSHES
Item Number
Description
Item Number
Description
E81668-00
Pad Driver, 13"
EP50200
Strobe Light Installed on Machine
E81681-00
Brush, General Purpose 13" 0.3mm
E88951-00
Squeegee Blade Kit, 36.5"
E82850-00
Brush, Medium Duty 13" 0.3mm
E22261-00
Squeegee Blade Kit Poly, 36.5"
E82851-00
Brush, Heavy Duty 13" 0.9mm
E22262-00
Squeegee Blade Kit Latex, 36.5"
E82852-00
Brush, Tynex 13" 1.0mm
E22095-00
Brush Skirt, 26" Complete Set
E22091-00
Pad Driver, 16"
E88953-00
Squeegee Blade Kit, 42.75"
E22093-00
Brush, General Purpose 16" 0.3mm
E22264-00
Squeegee Blade Kit Poly, 42.75"
E89557-00
Brush, Medium Duty 16" 0.3mm
E22265-00
Squeegee Blade Kit Latex, 42.75"
E22092-00
Brush, Heavy Duty 16" 0.9mm
E89550-00
Brush Skirt, 32" Complete Set
E22094-00
Brush, Tynex 16" 1.0mm
Stealth™ DRS Series Brush Options
Stealth™ DRS Series Common Parts
