BETCO E29926-00, Operator'S Manual

9

11. BATTERY MAINTENANCE AND DISPOSAL

For maintenance and recharging, comply with the instructions recommended by 

the battery manufacturer.  Particular attention must be paid when choosing the 

battery charger, if not supplied with the machine, since there are different kinds 

according to the type and capacity of the battery.

When the battery reaches the end of its working life, it must be disconnected by 

expert, trained personnel, then lifted to remove them from the battery compart-

ment.  Dead batteries are classified as dangerous waste and must be properly 

recycled. 

12. BATTERY CONNECTION AND BATTERY CONNECTORS

•  The machine is configured to operate with 4 – 6 volt batteries.  

•  The batteries are connected in series to achieve a total of 24 volts.  

•  Connect the Anderson plug from the batteries to the Anderson plug on the 

machine.

•  Only use electric cables supplied by the manufacturer.

13. BATTERY CONNECTION AND BATTERY CONNECTORS

•  Make sure the recovery tank is empty.

•  Move the machine to the battery charger.

•  Make sure that the key switch is in the OFF position.

•  Engage the parking brake.

•  Grip the handle under the seat to open the recovery tank.

  Lift the recovery tank until it hooks to the end of the safety clamp.

•  Disconnect the Anderson plug connection between the batteries and the 

machine.

•  Connect the Anderson plug from the batteries to the Anderson plug on the 

charger.

•  After recharging the batteries completely, the Anderson plug on the batteries 

must be connected to the Anderson plug on the machine.

•  In order to prevent damage to the batteries, it is essential to avoid their com-

plete discharge.

•  Attempt to recharge batteries before the battery indicator begins flashing the 

red discharged light.

•  Check that the battery charger is suitable for the batteries installed in terms of 

capacity and type.

You are advised to always wear protective gloves, to avoid the risk 

of serious injury to your hands. 

You are advised to only lift and move the batteries with lifting and 

transportation means suitable for the specific weight and size. 

MACHINE PREPARATION