15
ON COMPLETION OF THE WORK
At the end of the work day, before performing any type of maintenance:
1.
Close cock (3).
2.
Raise base (1).
3.
Raise squeegee (2)
4.
Turn off brush switch 1).
5.
Turn off aspiration motor switch (2).
6.
Move the machine to the water disposal point.
7.
Turn key (3) to turn the machine off.
8.
Lift hood (1). This frees recovery tank drain tube (2).
9.
Remove the drain tube from its seat, unscrew the drain plug and empty the recovery tank (Lift the left
side of the tank a few centimeters to accelerate final emptying phases). These operations must be
performed wearing rubber gloves to protect against contact with dangerous solutions.
10.
The squeegee should be raised when the machine is not in use to prevent permanent distortion of the
rubber strips.
11.
Remove the brushes and clean them with a jet of water (see "BRUSH REMOVAL" below).
ATTENTION!
This operation has to be carried out using gloves to protect from
contact with dangerous solutions.
12.
Push the knob (1) toward the rearpart of the machine and unhook the splash guard.
13.
Extract the hopper and clean it thoroughly.
ATTENTION!
This operation has to be carried out using gloves to protect from
contact with dangerous solutions.
14.
Lift the sweeping group on completion of the work to avoid brushes deformation.
1
