16
DAILY MAINTENANCE
1. CLEANING RECOVERY TANK
1.
Open the hood (1).
2.
Remove the drain tube (2) from its seat.
3.
Empty the tank through the drain tube by turning the knob a few turns and then pulling out the
plug.
ATTENTION!
This operation has to be carried out using gloves to protect from
contact with dangerous solutions.
1.
Remove plug (1) from the recovery tank..
2.
Pull out the filter with its foam-protection unit.
3.
Rinse the inside of the tank thoroughly with a jet of water. Slightly lift the tank, using its handle, to
improve dirt removal.
4.
Put the tank back in the machine and put the plug back on the drain tube.
ATTENTION!
This operation has to be carried out using gloves to protect from
contact with dangerous solutions.
2. CLEANING THE SUCTION FILTER
1.
Remove the suction unit from the tank.
2.
Remove the black guard by making a circular movement (1).
3.
Detach filter (2) and clean it carefully with a jet of water.
4.
Reinstall everything by performing these procedures in reverse order
3. CLEANING THE SQUEEGEE
The squeegee must be in perfect working condition to achieve a good drying process: it must be clean
and its rubbers must be in good condition. Proceed as follows to clean the squeegee:
1.
Remove it from the machine by pulling pin (1) out from column (2). Clean the interior with a jet of
water.
2.
Loosen knobs (3), remove block (4) and check that there is no dirt inside.
3.
Check the condition of the rubbers and replace them as necessary.
4.
Replace everything on the machine.
2
1
