ADJUSTMENTS
AND
INSPECTIONS
MAXIMA
Doc. 10004809
Emesso dec
-06
Rev. 00
Pag.
1 di 7
ADJUSTMENTS AND INSPECTIONS / ALL MODELS
READ THE OPERATING AND MAINTENANCE MANUAL
Inspection Electrical Equipment
1. Check functionality electrical equipment:
switches, motors, solenoid valve.
2. Check functionality control coupling-uncoupling
brush, where this is assembled.
3. Check the condition of the fuses placed behind
the rear grey panel
4. Check functionality
chopper
(traction machine)
5. If necessary set the
chopper card
proceeding
as follows
:
x
Lift the machine (traction wheels must be free)
x
Take off the rear screws to open the panel;
take off the fixing screw and lower the
complete electric group
x
Insert the tester prods (V-DC) onto the faston
M+
and
M-
of the chopper card
x
Switch on through the general key
x
Adjust
trimmer “ACC”
(acceleration) rotating
the left screw up to the end, then position it on
45°
6. Press onto the lever placed on the handle bar in
forward movement, until the release of the
drive relay is heard, then stop.
7. Adjust the
trimmer Vmin
(minimum)
until
the value on the tester is read, which is
between
3-5 V.
