ADJUSTMENTS
AND
INSPECTIONS
MAXIMA
Doc. 10004809
Emesso dec
-06
Rev. 00
Pag.
2 di 7
8. Push the lever on the handle bar completely
forward, read on the tester the tension value:
this should be equal to the battery tension,
otherwise act upon the
trimmer Vmax
(maximum voltage
)
, until the tester indicates
the correct value.
9. Recheck the minimum values with the
trimmer Vmin
. Bring the lever back to try the
drive: check that the measured tension is less
than the maximum value.
10. Check the motor braking releasing the drive:
the machine must stop within 1 metre.
Inspection Water Supply
1. Check the cleanness of the transparent
solution filter
.
Check also
eventual water leakages.
2. Fill completely with water the solution tank
.
3. Check the tightness of the hoses, the
solenoid valve
* and the
complete opening and closing of the water cock
.
* THE SOLENOID VALVE IS AVAILABLE ONLY ON MACHINES WITH
KIT
4. Check that the detergent solution, when the cock is open, arrives
with continuity onto the floor
.
5. With the closed cock, check that there are not any solution
leakages
Inspection Suction
1. Check the cleanliness and functionality of the
filter float
.
2. Check the air seal of the
cover
on the recovery tank
.
3. Check the connections and their tightness of the
suction hoses
and the
squeegee hose
.
4. Check the tightness of the
hose
and of the
exhaust plug
.