ADJUSTMENTS
AND
INSPECTIONS
MAXIMA
Doc. 10004809
Emesso dec
-06
Rev. 00
Pag.
5 di 7
3. The dimension of the
spring belt tightener
should be always of
27mm in compression.
The models equipped with automatic traction, that means BT, carry
out the same operation what the brushes inclination concerns.
PS: As the brushes are assembled on flexible couplings, with
automatic traction, these models do not need other adjustments
regarding the brushes group.
Adjustment sweeping system 50BS – BTS semiautomatic drive BS
For the BS types (semiautomatic drive) in case there isn’t an
uniform adherence of the brushes on the floor so a incomplete
cleaning function act as:
x
lower the sweeping system
x
Unscrew the right
M8
screw
x
Let the cylinders adhere equally to the floor
x
Block the M8 screw
Adjust the traction power, put the inclination lightly in the front part
the deck and block the
M8 screw
.
For the automatic traction types (BTS) make the same adjustment
for a complete equal cylinder adherence, then check the work
surface of both cylinders.
x
Wet a little the cylinders (with water)
x
Bring the machine on a dry levelled surface
x
Lower the sweeping system until the cylinder touch the floor.
Rise the cylinders and check the imprint left. It has to be a
rectangle and uniform on both sides
x
In case you have to modify the set up of the system,
unscrew the M8
at the left of the sweeping system, adjust
the deck in the parallel position, so block the screw
