10
PREPARING THE MACHINE
7.
FASTENING THE HANDLEBAR
For packing purposes the handlebar is supplied folded and must be put into its working position.
Proceed as follows to do this:
1.
Lift the handlebar, pulling up the lever indicated by the arrow
2.
Position the ma chine in its working position
3.
Mount the recovery tank on the handlebar tube using the two hooks
4.
Insert the tubes into the fittings that exit from the ring of the recovery tank
8.
DETERGENT SOLUTION
Fill the solution tank with clean water at a temperature that does not exceed 50
°
C. Add liquid
detergent in the concentration and according to the procedures recommended by the manufacturer.
Use only a minimal percentage of detergent to prevent formation of an excess amount of foam
since too much foam may damage the suction motor.
ATTENTION:
Always use low-foam detergent. Introduce a small amount of
anti-foam detergent in the recovery tank before starting to work to be sure
to prevent foam from being generated. Never use pure acids.
9.
RECOVERY TANK
Make sure that the recovery tank is properly inserted in its housing and that the tubes are properly
inserted in the tank elbows.
Check that the plug is properly closed.
