13
13. RECOvERY TANK
To properly turn off the machine after use or before performing any maintenance:
1. Turn off the solution control switch (
3
).
2. Turn off the vacuum switch (
2
).
3. Turn off the main switch (
1
).
4. Raise the squeegee lift lever on the back side of the handle tube.
5. Transport the machine to the location provided to drain water.
6. Disconnect the vacuum hoses and remove the recovery tank from the machine.
7. Remove the recovery tank cap and tilt the tank to empty the waste water.
8. Disconnect the quick connection at the front of the machine and remove the
solution tank.
9. Remove the cap from the solution tank and tilt the tank to dump any remaining
solution.
10. Remove the brush and rinse it with clean water.
WARNING: Always wear gloves when doing this operation to protect
yourself from contact with hazardous chemicals.
WARNING: Never tilt the machine backwards and rest on the handle
if there is water in the recovery tank. This may spill water into the
electrical panel and cause permanent damage to the machine.
TURNING OFF THE MACHINE
Summary of Contents for Genie B
