PROBLEM
CAUSE
POSSIBLE SOLUTION
Brushes will not lift
Brush lift handle is in the heavy
brush pressure position.
(a) If brushes are on scrubber;
pull up on brush lift handle,
then push in and lower.
Brush lift pedal should now
lift brushes.
(b) If there are no brushes on
scrubber; push in on brush
lift handle and hold in. Brush
lift pedal should now lift
brushes.
Scrubber does not remove any
water from the floor. (All water
runs out the ends of the
squeegee.)
(a) Obstruction in the squeegee
or in the vac hose from
squeegee to recovery tank.
(b) Recovery tank is full.
(c) Leaking recovery lid gasket.
(d) Squeegee hose is
disconnected.
(e) Vacuum motor not running.
(a) Remove obstruction.
(b) Empty recovery tank.
(c) Repair/replace gasket.
(d) Connect hose to squeegee.
(e) Replace faulty switch,
solenoid, vacuum motor, or
wiring connection problem.
Scrubber does not remove all
water from the floor. ( Some
water runs out the ends of the
squeegee unless you walk very
slowlyf.)
(a) Obstruction in the squeegee
or in the vac hose from
squeegee to recovery tank.
(b) Leaking recovery lid gasket.
(c) Vacuum intake screen in
recovery lid is dirty
(d) Squeegee is not properly
adjusted.
(a) Remove obstruction.
(b) Repair or replace gasket.
(c) Clean screen or replace.
(d) Adjust squeegee per
instructions in manual.
Streaks of water are left on the
floor.
(a) Trash is caught under
squeegee blade.
(b) Squeegee tilt not properly
adjusted.
(c) Main squeegee blade worn
or damaged.
(d) Reinforcing squeegee blade
is turned incorrectly for the
application.
(a) Remove trash. Sometimes it
works to lift squeegee, back
up a little, then lower
squeegee and resume
scrubbing.)
(b) Adjust squeegee per
instructions in manual.
(c) Flip or turn main squeegee
blade. Replace if necessary.
(d) Flip blade upside down and
try it. This changes deflection
on the main squeegee blade.
No solution flow
(a) Solution tank is empty.
(b) Damaged solution cable or
solution valve.
(c) Solution hose is obstructed.
(d) Fill solution tank.
(e) Repair or replace
components as needed.
(f) Remove obstruction.
Solution flow does not stop
Damaged solution cable or
solution valve.
Repair or replace components as
needed.
TROUBLE-SHOOTING
- 50 -
Summary of Contents for PowerBuff AS2600T
