Operating Procedures
(continued)
x
When you stop scrubbing an area.
o
Turn off brushes (brushes or pads can wear through the wax if left
running in one place)
o
Turn off solution flow (cleaning solution control lever (item 17))
o
Turn off vacuum (vacuum motor control switch (item 7))
o
Turn off traction drive on traction drive model (traction on/off switch (item
9))
x
Before taking scrubber back to storage area
o
Lift brushes
o
Lift squeegee
x
To dump dirty water from recovery tank (item C)
o
Lift recovery dump hose (item 12) with plug for recovery dump hose (item
10) from hooks.
o
Hold end of hose so that the dirty solution will flow into the appropriate
place (such as a drain) when plug is removed.
o
Loosen T-handle on plug for recovery dump hose (item 10) and remove
plug from hose. Dirty solution will flow from tank. (Note: do not completely
unscrew T-handle from plug).
o
Replace plug and tighten. Hang hose back on hooks.
x
Machine storage for the day
o
Brushes in up position
o
Squeegee in up position
o
Recovery tank emptied (Note: it is best to occasionally rinse it out with
clean water).
o
Solution tank emptied (especially if machine is to be left for longer than a
day).
o
Turn off all switches. (Note: if traction on/off switch is left on for more than
20 minutes without the machine moving, then the traction control
electronics will automatically power down. To reset them, simply turn the
traction on/off switch off and then back on).
- 17 -
