11
MACHINE PREPARATION
15. ADJUSTING THE SQUEEGEE HEIGHT
The height of the squeegee must be adjusted based on wear of the squeegee. To
do this, turn the knob (
2
) counter clockwise to raise the squeegee, and clock-
wise to lower it.
Note: the right and left wheels must be adjusted to the same level, so the
squeegee works parallel to the floo
r.
16. ADJUSTING THE SQUEEGEE INCLINATION
During working operation, the rear squeegee blade is slightly bent backwards
(by about 0.2 in (5 mm)) uniformly over its entire length. If it’s necessary to
increase the bend of the squeegee blade in the center, you must tilt the squeegee
backwards, rotating the adjuster (
1
) counter clockwise. To increase the bend of
the squeegee at the outside edges of the squeegee, rotate the adjuster clockwise.
After adjustment, tighten the jam nut.
17. RECOVERY TANK
Check the drain hose cap (on the rear of the machine) to ensure it’s closed.
