5.5.2 Setting the sensitivity for the magnet testing (for the UV/MG model)
If the
"MG"
button is pressed once, the value
"MG1"
appears on the stack display (see fig.
9).
"MG"
stands for magnet testing and
"1"
refers to the lowest testing sensitivity. To
increase the testing sensitivity, press the
"MG"
button again.
"MG 2"
then appears on the
stack display (greater sensitivity). The devices saves this setting after 1.5 seconds and
switches to stand-by mode.
5.5.3 Setting the width detection (optional)
If the
"SIZE"
button is pressed once, the value "5, 3" appears in the stack display (see fig.
10). The value "5" shows that the width detection has been activated and "3" shows the
setting for the greatest sensitivity, i.e. a measuring setting of 4 mm.
To switch to medium sensitivity "4", press the
"SIZE"
button again. The medium setting "5"
represents a measuring value of 5 mm or more.
The lowest sensitivity level "4" represents a measuring setting of 6 mm or more. The device
saves this setting after 1.5 seconds and switches to stand-by mode.
9
Fig. 8
Fig. 9
Fig. 10
5.5 Setting the sensitivity for detecting counterfeit notes
Please note: The sensitivity setting may not be carried out when the device is
operational.
5.5.1 Setting the sensitivity for the UV testing
If the
"UV"
button is pressed once, the value
"UV1"
appears on the stack display (see fig.
8).
"UV"
stands for UV testing and
"1"
represents the testing sensitivity. If the testing is to
be more sensitive, press the
"UV"
button again.
"UV2"
then appears on the stack display
(greater sensitivity). The device saves this setting after 1.5 seconds and switches to stand-
by mode.
-BJ05_Anleitung engl. 01.11.2006 8:30 Uhr Seite 9
