Installation:
1.
Position:
It is advisable to place and install the Parking Lock in the center of the parking lot.
2. The unit should be installed on plane and dry surface, for example blacktop. Take the key (inclu-
ded in the delivery), unlock and open the upper cover of the drive housing and lift the cover. Fix
the lower part of the drive housing with 3 bolts (Included in the delivery) into the ground by using
the designated spots.
3. Before initial setup, charge the battery for at least 10 hours. Take the battery out of the holder and
detach (turning off) the connecting cable from the drive port. Connect the battery cable with the
power adapter (included in the delivery) and plug into a power outlet. After the battery is fully char-
ged insert the battery back into the designated holder. Put the upper cover back on the drive unit
and lock the cover again.
Attention! The Parking Lock works properly only in the locked position. Remove the key and your
Parking Lock is ready for use.
4. By pushing the upper two buttons of the remote control the barrier bail can be placed up and
down. The operation of the barrier bail is also indicated by the indicator light located in the front.
The range of the infrared remote control averages 5 meter. The Parking Lock can be operated con-
veniently out of the car.
5. In case of unauthorized try of use by pulling down the barrier bail, alarm sounds for a short time
and the barrier bail goes up automatically which insures that no unauthorized person can be using
your parking spot.
6. The durability of the battery averages about 3 months depending of the frequency of use. After
that the battery has to be recharged for another 10 hours.
Self learning of remote control in order to operate with only one
remote control more then one Parking Lock
1. Open the black cover
2. Take out the battery
3. Open the white air protected lid
4. Install the battery
5. Open the white box
6. Press the small black button, then the indicator light will flash 3 times in order to delete the
memory of the previous setup.
7. Press the small button again, the indicator light will flash 3 times again. When the indicator light
flashes the second time, press the A button on the remote at the same time. This is in order to set
the new memory.
8. Now you can use one remote to control 2 parking lock units. If you would like to operate more
Parking Lock units repeat step 1 to 7.
Parking Lock Anleitung 23.02.2009 12:49 Uhr Seite 3
The range of the radio remote control averages 15 meters.