Indoor Use Only
Made in China H205412INST022015
5
2.
Check that all the light strings and umbilical cords are all plugged into the main wiring harness for that
section. Each light string should be plugged into the main wiring harness receptacle.
3.
Check the fuse bulbs in the light strings. There are 3 in each string. See instructions below.
•
If a light or the entire string still fails to light after checking if plugged in and fuses are intact, look for damaged,
missing, or burnt-out bulbs. Replace with included replacement bulbs. See instructions below.
•
If the tree is leaning:
1.
Check that the screws in the tree stand securing the bottom tree section are tightened evenly.
2.
Check to see if the bottom section is inserted into the stand straight. Loosen screws SLIGHTLY and adjust
bottom section as needed to straighten. Tighten each screw evenly again to secure.
3.
Ensure the stand is placed on a smooth flat surface.
Fuse Replacement for Outlet Plug
:
A.
Unplug power cord from receptacle or other outlet device. Do not pull on
cord.
B.
Slide open fuse access cover on top of plug.
C.
Turn fuse holder over and remove fuse.
D.
Risk of fire. Replace fuses only with correct fuses listed above (provided
with product).
E.
Turn holder face up and place new fuse(s) into previous fuse location.
F.
Slide fuse access cover closed.
Fuse Replacement for Light String
:
A.
Unplug power cord from receptacle or other outlet device. Do not pull on
cord.
B.
Locate the burned out fuse bulb on the light string (brown base with
white tip). Unlatch the bulb holder and remove bulb.
C.
Replace fuse bulb with new. Make sure to use a fuse bulb as replacement
(brown base with white tip). Close fuse latch.
Main wiring harness receptacle
Light string plug (into Main Wire Harness)
Lock to Lock umbilical cord
