Beton Trowel nv
Nijverheidsstraat 11
1840 Londerzeel/Belgium
Tel: +32 (0)52 315 350 - Tel: +32 (0)52 315 351
Fax: +32 (0)52 303 739
E-mail: info@betontrowel.com
BE 0821.249.312
www.betontrowel.com
BNP FORTIS:
ING:
BE81 0015 9813 5624
BE
- GEBABEBB
BBRUBEBB
Pag.
5/32
Operation
1
Use
The trowel has been developed to float and finish the edges of concrete floors, up to
perimeter walls, around columns and small areas, eliminating tiring hand troweling and
increasing overall productivity and quality.
2
Safety precautions
❖
Always keep unauthorized, inexperienced, untrained people away from this machine.
❖
Rotating and moving parts will cause injury if contacted. Make sure guards are in
place. Keep hands and feet away from moving parts.
❖
Fuel the machine only when the engine is stopped, using all necessary safety
precautions.
❖
The engine must always be stopped before attempting any repair or adjustments.
Ignition switch should be off.
❖
To avoid slipping and loss of control when starting the trowel, the operator should
maintain good footing. It is recommended that the operator wear safety shoes for
added protection.
❖
Be careful when working around pipes or ducts protruding from the floor or slab
edges. If the trowel blades hit such obstacles, damage to the machine or possible
operator injury may result.
❖
When starting the machine, do not exceed 1/3 throttle position. A higher setting may
cause the centrifugal clutch to engage and the handle to rotate.
❖
Be careful not to come in contact with the muffler when the engine is hot, serious
burns may result!
❖
Over time, the blades will form a sharp edge. Be careful when handling the old
blades.
Never operate the machine in an explosive atmosphere, near combustible
materials or where ventilation does not clear exhaust fumes. Repair fuel leaks
immediately. Refer to your engine owner’s manual for more safety instructions.
