Beton Trowel nv
Nijverheidsstraat 11
1840 Londerzeel/Belgium
Tel: +32 (0)52 315 350 - Tel: +32 (0)52 315 351
Fax: +32 (0)52 303 739
E-mail: info@betontrowel.com
BE 0821.249.312
www.betontrowel.com
BNP FORTIS:
ING:
BE81 0015 9813 5624
BE
- GEBABEBB
BBRUBEBB
Pag.
6/14
2
Initial setup
Upon removing the screed from its box for the first time, you will find the base unit
with the handles removed for shipping. The left handle is sitting freely in the box,
while the right handle is attached to the base unit by its electrical cable and throttle
control cable. The throttle control cable is not connected to the engine during
shipping to avoid damage to the cable and engine.
To connect the throttle cable, first set up the handles using the clamps and hex key
provided. Set the length and rotation to suit the operator. Then:
Open the Honda engine air filter cover by gently squeezing the clip on the
inside front of the black filter housing, and rotate the housing cover back out of
the way.
Pull the throttle cable over to the engine throttle wheel.
Rotate the silver throttle wheel so that the larger hole is pointing toward the
top of the engine.
-Slide the stainless steel throttle cable through the slotin the throttle wheel.
Pull the stainless steel throttle cable downward to insert the slug fitting into the
large hole in the throttle wheel.
Place the threaded fitting of the throttle cable conduit into the clamp below the
throttle wheel.
Tighten the nuts of the threaded fitting onto the clamp to lock the conduit in
place. Adjust the tension and length of the throttle cable by moving these nuts.
With the throttle grip at the end of the right operator handle released, the
throttle wheel on the Honda engine should be at the zero position.
-After verifying the operation of the throttle cable by squeezing the throttle
grip a few times, replace the air filter cover on the Honda engine. Your
screed is now ready to use!
