Congratulation on your purchase of this headrest monitor syetem.
The product is designed and built to deliver excellent video quality
and long lasting high performance, For best results please consult
a professional mobile eletronics installer for application advice or
troubleshooting. Please read these instrutions thoroughly before
installation.
1. Remove the exising headrest from the seat.
2. Adjust the pots of the new earest to fit thr holes in the seat where
the headrest will e installed. The post can br moved together or
apart grasp one post in each hand, move the poste in opposing
or directions(like they were walking) while pushing them toward
each other or away from each other.
3. Insert the cable in the proper hole. Insert the posts into the holes
in the seat and carefully work the headrest into position. Make
sure the cable is not pinched.
4. Run the cable down the seat and out to the location of the video
source unit (such as a DVD player).
5. Connect the wires as indicated:
a. Red: Connect to a sw) 12 volt source (ACC). Use a
lead that has(+) 12V when the ignition on or in the ACC position
so the monitors turns off when the key is in the off position.
Wiring the monitors
hot
could cause your battery to run down
when the engine is not running.
b. Black: Connect to a good chassis ground.
c. Reversing the polarity of the red and black leads will damage
the monitor.
d. Connect the video input connector to the video output from
the source unit(i.e. DVD player)
e. Test the syetem.
“
”
Installation Instructions
UNIVERSAL HEADREST WITH PRE-INSTALLED
MONITRO OWNER
MANUAL
’
Operating Instructions
3
2
Operating Instructions
HEADPHONE JACK
Headphone output
POWER
MENU
AV
AV2
Adjustable steel Pipe
PIPE
AV
AV2 Inputs
