Getting Started
Shake cartridge well.
1
Remove sealing
foil from cartridge.
(2)
Insert cartridge all the way into the chamber
in the direction of the arrows printed on the
cartridge.
Return chamber cover in a downward/inward
motion with minimum pressure until it locks
into place
2a
2b
Remove cartridge chamber cover by an outward/upward
motion with minimum pressure.
3
4
Power Connection
Note: Once Cartridge is inserted into
the BA-008, please make sure not to tilt
the unit in order to avoid spillage of the
IMPORTANT:
removing and replacing cartridge. Also,
the BA-008
DC Model
Connect the power cord to the inlet below
the Programing buttons.
Plug the power block into an AC outlet within reach
of the location you have chosen for your BA-008.
5
6
Rechargeable Battery / DC recharging
Connect the power cord to the inlet below
(not included in package)
the Programing buttons (a), Plug the power
block into an AC outlet , allow for at least a 10
hour preliminary charge , once charge is com-
-
pleted, choose the most appropriate location
for your BA-008 between charges
Warning: The BA-008 should be used only
with the power pack provided by the manufacturer.
Programming
Mounting
9
10
11
Note: when programming, please remember not to
tilt unit in order to avoid unnecessary spillage
7
- Press lightly for 2 seconds in
order to operate the BA-008. Repeat this action
when you wish to turn off the unit.
Operating level selection buttons
“Low” – Indoor area up to 150 sqf
“Medium” – Indoor area up to 500 sqf
“High” – Indoor area up to 800 sqf
(7)
(8)
(9)
Wall Mount
Pedestal
Wall Mount Installation
For optimal performance: it is
recommended to install the
BA-008 wall mount in
proximity to a wall
air condition unit.
The pedestal provided will
further assist with stabilizing
the BA-008 on common
surfaces such as table tops,
bookcases, shelves etc.
8
Manual Pulse button - Press pulse button in order
to release an extra dose of Environmental probiotic
spray manually. Pulse size will be determined
according to the operating level program (High,
Medium, Low). Using the Manual Pulse button will
not interfere with the chosen operating scheme.
smaller better Air for print.pdf 1 10/7/2015 8:02:18 PM
Note: When operating the device for the first time, you
should adjust the “High” for the first three days and follow
these simple procedures on an ongoing basis:
– Indoor area up to 800 sqf
“10 Hour Pause”
– Will suspend
operation of the BA-008 for 10
hours
