INSTRUCTIONS FOR USE AND MAINTENANCE (TRANSLATION OF ORIGINAL INSTRUCTIONS)
1. PURPOSE
These instructions are intended for those who use the flyscreen such as the installer, maintenance person, owner or user.
With this instruction booklet BETTIO GROUP SAS wishes to provide Customers with a tool for better, correct use of installed flyscreens so as to
optimize their performance.
For correct and best use of the system it is therefore recommended that these notes be kept to hand for quick reference whenever required. Supple-
mentary information may be had in the Operating and Maintenance Guide and the Technical File available at the Company’s offices.
2. SCOPE
These instructions refer to the following model:
SCENIKIT
®
, for which the contents are suitably adapted.
3. REFERENCES
These instructions have been prepared, as have other instructions for use applied to the product, in accordance with point 1.7.4 of Directive 2006/42/
EC taking into consideration normal conditions of use of the product, to inform operators and users also of the residual risks that the product presents.
4. ENVISAGED USE
The function of the installed flyscreen system is solely to provide protection against the intrusion of insects and small animals into the environments to
be protected.
Any use other than has been described above is considered incorrect and is therefore forbidden, since the relative working
conditions will not have been taken into account when the manufacturer analysed the risks and consequently there could be no
specific protective devices fitted. Do not lean against the mesh. Do not let go of the handle rail until the mesh is fully rewound.
Misuse relieves the manufacturer from all liability for any injury to persons or damage to property.
Failure to comply with the conditions of use automatically invalidates any type of warranty given by the manufacturer.
5. OPERATOR REQUIREMENTS
Normal use of the flyscreen is allowed for non-professional users provided they are aged 12 and over. Installation, repair and extraordinary mainte-
nance must be carried out by qualified technical personnel.
6. RECOMMENDATIONS FOR INSTALLATION
Installation must be carried out in full compliance with Italian Legislative Decree 81/2008 and subsequent amendments and additions for all that con-
cerns the safety of persons. In accordance with current laws, the client and the installer are both responsible with regard to safety. Before using any
equipment such as drills, screwdrivers, work platforms, scaffolding, steps and all personal protection equipment (slings/harness, safety belts, gloves,
safety shoes, helmets, etc.), check that they are in compliance with regulations and in good condition. Use suitable slings or harnesses. If there is
more than one installer, the work must be coordinated and the tasks and responsibilities defined. Users must abide by the applicable safety instruc-
tions received (POS). If the product is to be installed on any floor above ground level, the area must be cordoned off and supervised while the product
is being raised to the relevant floor so that no person is under any suspended load.
7. INSTALLATION OF THE MECHANICAL STRUCTURE
Incorrect installation can cause injury to persons. Carefully read the instructions for correct fixing of the product so that there is no risk of
it falling down
.
62
Sicurezza - Normative
Safety - CE rules
Sicurezza - Normative
Safety - CE rules
®
