18
4.7 Changing the weight unit
You can change the weight unit either using the “beurer HealthManager Pro” app or directly on the scale:
1. Press and hold the SET button
5
for 4 seconds. “unit” appears on the display
1
.
2. Use the
button
2
or
button
3
to select the desired weight unit (kg, lb or stlb). kg = kilograms,
lb = pounds, stlb = stones
3. To confirm, press the SET button
5
repeatedly until the display
1
switches off.
4.8 Deactivating
Bluetooth
®
and WIFI
To deactivate
Bluetooth
®
and WIFI, proceed as follows:
1. Press and hold the SET button
5
for 4 seconds.
2. Press the SET button
5
repeatedly until “on” appears on the display 1.
3. Select “oFF” with the
button
2
or the
button
3
.
4. To confirm, press the SET button
5
repeatedly until the display
1
switches off.
Note:
Please note that the
Bluetooth
®
and WIFI function is then NO longer possible.
To reactivate it, set it from “oFF” to “on”.
5. WHAT IF THERE ARE PROBLEMS?
5.1 Restarting scale
If it is necessary to restart the scale (e.g. scale software freezes), briefly press the reboot button
6
. In this
case, the power supply is briefly interrupted.
5.2 Resetting the scale to factory settings
To reset the scale to the factory settings, press and hold the SET button
5
and briefly press the reboot button
6
. Press and hold the SET button
5
until “rSt” appears on the display.
5.3 Updating scale software
The app will inform you when a new software update is available.
1. Briefly press on the scale to switch it on.
2. Press and hold the
button
3
for 15 seconds. The scale automatically checks for an update and down-
loads it. This may take a few minutes. If the update is successful, “PASS” will be displayed. If the scale is
already up to date with the latest software version “utd” appears.
5.4 Messages and errors
Display
Cause/remedy
Discrepancy in
weight
Incorrect zero point (e.g. in the event of a change of location or temperature fluctua-
tion): briefly press on the scale until the current weight is displayed, then remove your
foot so that “0.0” flashes.
Scale is placed on carpet or uneven ground: the surface must be hard and level.
PAir
Bluetooth
®
needs to be paired: start/allow pairing/bonding on your smartphone (note
any messages in the status bar/notification bar), and confirm the 6-digit pairing code
using the SET button
5
on the device and on the smartphone.
“USE APP” or
flashing
The scale can be connected to the app via
Bluetooth
®
: do not connect it via the
Bluetooth
®
settings on your smartphone, only via the app.
UnSt
This weight measurement was unstable: stand still during the measurement.
