20
6. Initial use
Initial use of camera
1. Place the camera on a level, firm surface and point the camera lens at the area that
you wish to monitor. Ensure that there are no other electrical devices in the proxim-
ity of the camera.
WARNING
Do NOT position the camera within reach of the baby!
2. Connect the small end of the camera mains part plug to the camera.
3. Connect the other end of the mains part plug to the socket.
4. Move the ON/OFF switch to “ON” to switch on the camera. The function light on the
camera begins to glow blue.
5. Push the ON/OFF switch downwards to switch off the camera.
Initial use of parent unit with battery
1. Remove the assembly clip.
2. Open the cover on the rear of the parent unit by sliding it downwards.
3. Insert the battery included in delivery as shown.
4. Slide the cover on the rear of the parent unit back up again, until you can hear and
feel it slot into place.
5. Attach the assembly clip again.
6. Press the ON/OFF button
to switch on the parent unit. If the camera is already
switched on, the transmission image from the camera will automatically appear on
the screen. If the camera is still switched off, an acoustic signal is emitted and the
following symbol appears on the monitor: “ ”.
Initial use of parent unit with mains part plug
1. Connect the small end of the parent mains part plug with the parent unit.
2. Connect the other end of the mains part plug to the socket.
3. The parent unit switches on automatically. Press the ON/OFF button to switch off the
unit. If the parent unit and camera are both already switched on, the transmission
image from the camera will automatically appear on the screen of the parent unit.
