18
Automatic programs
The foot bath has one preset and three individually selectable programs:
PO
= Manual operation / Program OFF (default)
P1
= Bubble and vibration massage on simultaneously for 10 seconds and pause for 5 seconds
P2
= Bubble massage and pulsating vibration alternating for 15 seconds each
P3
= Bubble and vibration massage alternating for 10 seconds each
1. Select the desired program (P1, P2, P3) using the “Programs” function button
15
. The LED of function
button
15
starts to light up. The currently set program is briefly displayed on the LED touch display
1
.
The display switches back again to the water temperature.
2. To change to manual mode, press function button
15
again until PO appears in the LED touch display
1
. The function button
15
LED turns off.
Bubble massage
You can switch a bubble massage on during use.
1. To switch the bubble massage on, press the “Bubble” function button
16
. The LED of function button
16
starts to light up.
2. To switch the bubble massage off again, press function button
16
again. The LED turns off.
Timer function
You can set a timer time of between 20 and 60 minutes (in 5-minute increments) on the foot bath. After this
time has passed the foot bath switches off automatically. Initially, the timer time is automatically preset to
20 minutes.
1. Use the “Timer” function button
18
to select your desired relaxation time. The selected timer time is shown
briefly in the water temperature / timer time display
17
before the water temperature is displayed again.
2. You can display the remaining relaxation time during use by pressing function button
18
once.
3. If function button
18
is pressed several times during use, the relaxation time is restarted.
4. As soon as the relaxation time has elapsed, the foot bath automatically switches to standby mode.
6. CLEANING AND MAINTENANCE
CAUTION
Make sure that no water gets inside the device! Make sure that the foot bath is switched off and
unplugged every time before cleaning.
1. After use, unplug the foot bath and empty the water via the narrow side.
2. To make it easier to empty the foot bath, we recommend carrying it with the straight side facing the body.
3. Then rinse the foot bath with clean water.
4. For hygienic cleaning, a mild, non-foaming/abrasive cleaning product can be used (e.g. neutral vinegar).
5. To dry out the air lines after cleaning, switch the bubble function on without water for approximately 1
minute. You can wipe any drops off with a cloth.
6. The storage bag for the pedicure attachments can also be used at the same time as a cloth to clean/dry
the foot bath.
7. To make cleaning/drying easier, you can remove the massage roller attachments
6
from the foot bath
by removing them with a gentle lever action.
8. After cleaning, store the foot bath in its original packaging and in a dry place. Do not leave the foot bath
open for prolonged periods of time.
Summary of Contents for FB 60
Page 3: ...3 8 9 10 22 1 2 3 4 7 6 5 14 12 11 17 18 16 15 13 19 20 21 ...
Page 108: ...108 ...
Page 109: ...109 ...
