14
1. Press the ON/OFF button
to start treatment.
2. Select the desired speed using the speed controller.
3. Select the desired direction of rotation using the buttons for clockwise and anti-clockwise
rotation.
4. Do not press too hard and always carefully move the attachments towards the area to be tre-
ated. Move the device towards the area to be treated and apply slight pressure while slowly
moving the device in circles.
5. Apply moisturiser to the treated areas after each use.
5. Cleaning
Warning
Before beginning cleaning, always pull the mains adapter out of the socket!
• Clean the base station and the hand-held device with a damp cloth. If it is very dirty, you can
also moisten the cloth with a mild soapy solution.
• For hygienic reasons, you may use alcohol and a cloth or brush to clean the attachments. Al-
low the attachments to dry afterwards.
• Do not use any chemical or abrasive cleaning agents.
• Ensure that no water enters the device. If this should happen, reuse the device only when it
has fully dried out.
• Do not submerge the base station and mains adapter in water or any other fluids.
6. What if there are problems?
Problem
Possible cause
Solution
Hand-held device will
not switch on.
Mains adapter not plugged in
Insert the mains adapter into the
socket.
No voltage at mains socket
Check your fusebox.
Hand-held device not connected to
base station.
Connect the hand-held device to
the base station.
7. Replacement parts and wearing parts
Replacement parts and wearing parts are available from the corresponding listed service
address under the stated material number.
Replacement part
Material number
Fine sapphire cone
163.301
Coarse sapphire cone
163.302
Felt cone
163.303
sapphire wheel (fine)
163.304
Sapphire wheel, coarse
163.305
Cylindrical cutter
163.306
Flame-shape cutter
163.307
Sapphire cutter, round
163.308
Nail cutter
163.309
Sandpaper attachment
163.310
Single-use attachments, 100 units
163.311