INSTALLATION GUIDE, WAVEE TOUCHLESS SWITCH
BEXAR TECHNOLOGY PARTNERS
Page
6
of
10
revision 2
Operation
When power is applied to the Wavee switch it will boot up for several seconds. Once it has completed
booting up the LCD will display the following images for searching (idle) and detected modes.
Searching
Motion Detected
While in searching mode the relay wires will be in their default state. When motion is detected the relay
wires will switch to their opposite state and the LCD will display the motion detected image. After a
configurable period of time the relay and LCD will switch back to their searching (idle) state.
By default, the Wavee switch is configured to sound a buzzer for 500ms when it goes into the detected
state. It will stay in the detected state for 5 seconds before returning to the searching state. These
default parameters and more can be changed using the Wavee Configurator mobile app.
