4
ELECTRICAL REQUIREMENTS
100 - 240 Volt 50/60 Hz 5 AMP (minimum) Fuse or Circuit Breaker.
Laundry Pro 2.0 is equipped with an AC to DC power supply.
NEVER USE AN EXTENSION CORD.
WATER REQUIREMENTS
A dynamic water pressure of greater than 20 psi / 1.37 bar and less than
60 psi / 4.13 bar is required to correctly operate your Laundry Pro 2.0.
See Cautions below.
WATER
OUTLET
WATER
INLET
INSTALLATION REQUIREMENTS
LOCATION CONSIDERATIONS
The Laundry Pro 2.0 must never be installed in areas where water
may freeze since the unit will always maintain some water in the unit,
the water valve, and hose areas. This can cause damage to internal
components. It is also recommended to avoid installation in areas of
high humidity, as it can effect the operation of the unit.
17.3” (43.94 cm)
5.19” (13.48 cm)
3.69” (9.37 cm)
Incoming water pressure must be greater than 20 psi / 1.37 bar. If your
household water pressure is greater than 60 psi / 4.13 bar, you must
install an in-line pressure reducer before installing Laundry Pro 2.0.
Failure to follow these instructions may result in water leakage, property
damage, personal injury, and may void your warranty. Water pressure
of 20 psi / 1.37 bar to 60 psi / 4.13 bar is required to correctly operate
your Laundry Pro 2.0. Low water pressure may prevent your unit from
operating properly and/or cause a failure in your washing machine’s
water valve.
The washer’s water valve may also not shut off completely. Check
the documentation supplied with your washing machine for exact
specifications. Your washing machine and cold water faucet must be
within 4 feet of the right side of the unit to use the inlet hose provided
with your Laundry Pro 2.0.
TO AVOID THE POSSIBILITY OF WATER DAMAGE, SHOULD A HOSE
LEAK, ALWAYS HAVE FAUCETS ACCESSIBLE AND TURN OFF
FAUCETS WHEN WASHER IS NOT IN USE. DO NOT USE WITH A
CARBON FILTER.
CAUTION:
