2.2.11
The burner base plate can now be removed by removing the ten screws
and lifting clear as shown below in figure 11. Tilt the assembly up at the
back as it is removed to clear the on/off switch from the inlet channel.
Unplug the wire from the receiver on the underside of the burner base
plate taking care not to damage the wires.
Fig. 11
2.2.12
The gas supply can be routed into the fire from the left, see
figure 12 below for dimensional information regarding position and
route of gas supply pipe.
Fig.12
Burner base plate held in
position by 10 off screws
14
Gas supply route
