background image

worse   in   certain   wind   conditions   (often   incorrectly   ascribed   to
'downdraught', which is in fact very rare), where air can be sucked
out of the room. The answer is to fit an air vent, as near to the fire
as possible, facing into the usual wind direction.
DOWNDRAUGHT:   Wind   can   blow  

down

  a   chimney   if   there   is

something   higher   nearby   such   as   a   tree,   hill   or   high   building.
Fitting an anti-downdraught cowl to the chimney top can cure this.
Types which cannot be swept through are not recommended.
POOR CHIMNEY DRAUGHT- Chimney draught in use MUST be
at least 12Pa. 

CHIMNEY FIRE: 

In the rare event of deposits inside the chimney

igniting   (roaring   sound   +   dense   smoke   and   sparks   from   the
chimney) immediately close the door, shut all air controls and call
the fire brigade. Prevent fires by using  

very dry fuel

 

and having

your chimney swept regularly.

 MAINTENANCE

MONTHLY

- With the fire cold, remove, clean and refit the throat

(or 'baffle') plate below the flue outlet. Check that the flue is clear
and unblocked, and that the door seals are sound.

ANNUALLY-   SWEEP   THE   CHIMNEY

  The   entire   length   of   the

chimney from stove to outlet should be swept annually, more often
if smoky fuels are used.

NEW PARTS 

Your stove has been extensively tested for safety -

please don't try to modify it and always obtain genuine spare parts

.

SURFACE FINISH

 Wipe the stove body with a slightly damp cloth

when cool. NEVER use aerosol spray or wax near the hot fire –
they   can   ignite.   Painted   steel   parts   can   be   refurbished   using
special spray paint. Coloured doors are traditional hand-applied
vitreous   enamel   -   it  

will

  have   small   surface   imperfections   and,

while virtually immune from fading, rust and scratches, it can chip.
Enamel cannot be repainted or repaired. 

Your   stove   generates  

VERY

  high   temperatures.   Eventually   the

internal parts will require replacement . Help parts to last by:

• Using only very dry logs
• Cleaning the throat plate regularly.
• Avoiding 'over-firing'

 PARTS AND ACCESSORIES

When ordering parts, specify the model of Portway Wood stove you have, and which colour.

Portway spares Tel. 01782 339034  Fax 01782 339028

1

Boost boiler for all free-standing models

2

Throat plate

3

Replaceable Liner - rear

4

Replaceable Liner - sides left or right

5

Replaceable Liner – base segments

6

Transparent window

7

Rope seal kit

8

Door (Various styles are available)

9

Window trims  - can be added at any time

10

Ashpan

11

Door catch

12

125980 Removable door handle

13

125920 Ashpan handle

14

Inner Baffle

15

Hinge Pin

16

Cast Top

17

Cast base trims

18

Grate

-

126110 Masonry fixing screws - self tapping.

-

Touch-up paint, black or charcoal.

Trentham Lakes, Stoke on Trent,  Staffordshire, England ST4 4TJ 

 www.bfm-europe.com 

 Tel 01782 339000  Fax 01782 339009

 4

The Portway stove designs are registered at the UK Patent Office and protected by Copyright © and UK Design Right, Glyn Hughes 2006-2009. Certain parts are UK Patent Applied 
For. This document printed 04/02/2014. We are always striving to improve these products and may change their specification without notice.

Summary of Contents for portway

Page 1: ...nd placed where it can easily be found INSTALLED AT LOCATION BY EMERGENCY CONTACT Flue Draught measured on commissioning Fuel used on commissioning I definitively assert that this installation is safe has been lit and demonstrated to the householder conforms with current building regulations and with these instructions SIGNED DATE TO FIND A QUALIFIED INSTALLER FUEL SUPPLIER or CHIMNEY SWEEP CONTAC...

Page 2: ...o the size given on page 1 This can sometimes be provided by air leaking around door frames etc it is commonly accepted that this alone may suffice for the first c 5kW in less well sealed buildings but in any case of doubt fit a purpose made air vent An extractor fan or another fuel using appliance in the same building can remove this air BOILER A slot in water boiler for domestic hot water and or...

Page 3: ...utely dry less than 15 moisture Fill the stove criss cross so air can circulate between logs Fill little and often Always have the airwash control at least a little open When first lighting or reviving a fire from embers use only very small thin dry sticks Don t empty the ash out until absolutely necessary JOINERY WASTE Dry wood offcuts will burn well but don t expect softwood waste to burn as cle...

Page 4: ...near the hot fire they can ignite Painted steel parts can be refurbished using special spray paint Coloured doors are traditional hand applied vitreous enamel it will have small surface imperfections and while virtually immune from fading rust and scratches it can chip Enamel cannot be repainted or repaired Your stove generates VERY high temperatures Eventually the internal parts will require repl...

Reviews: