BFT STOPPY CASE 500, Installation And User Manual

D811767_07

STOPPY MBB 219-500.C - STOPPY MBB 219-700  

9

D811943_03

apparecchio scartato, le pile o le batterie usate 

nei rifiuti domestici. Avete la responsabilità di 

restituire tutti i vostri rifiuti da apparecchia-

ture elettriche o elettroniche lasciandoli in 

un punto di raccolta dedicato al loro riciclo.

Tutto quello che non è espressamente previs-

to nel manuale d’uso, non è permesso. ll buon 

funzionamento dell’operatore è garantito solo 

se vengono rispettate le prescrizioni riportate 

in questo manuale. La Ditta non risponde dei 

danni causati dall’inosservanza delle indicazioni 

riportate in questo manuale.

Lasciando inalterate le caratteristiche essenziali 

del prodotto, la Ditta si riserva di apportare in 

qualunque momento le modifiche che essa ritie-

ne convenienti per migliorare tecnicamente, cos-

truttivamente e commercialmente il prodotto, 

senza impegnarsi ad aggiornare la presente 

pubblicazione.

USER WARNINGS (GB)

WARNING! Important safety instructions. Ca-

refully read and comply with the Warnings and 

Instructions that come with the product as impro-

per use can cause injury to people and animals 

and damage to property. Keep the instructions 

for future reference and hand them on to any 

new users.

This product is meant to be used only for the 

purpose for which it was explicitly installed. 

Any other use constitutes improper use and, 

consequently, is hazardous. The manufacturer 

cannot be held liable for any damage as a result 

of improper, incorrect or unreasonable use.

GENERAL SAFETY

Thank you for choosing this product. The Firm is 

confident that its performance will meet your ope-

rating needs.

This product meets recognized technical standards 

and complies with safety provisions when installed 

correctly by qualified, expert personnel (professional 

installer).

If installed and used correctly, the automated system 

will meet operating safety standards. Nonetheless, 

it is advisable to observe certain rules of behaviour 

so that accidental problems can be avoided:

- Keep adults, children and property out of range of 

the automated system, especially while it is moving.

- Do not allow children to play or stand within range 

of the automated system.

- The unit can be used by children over 8 years old 

and by people with reduced physical, sensory or 

mental capabilities or with no experience or neces-

sary knowledge on condition they are supervised 

or trained about the safe use of the equipment 

and understand the risks involved. Children must 

not play with the unit. Cleaning and maintenance 

must not be performed by unsupervised children.

- Children must be supervised to ensure they do not 

play with the device. Do not allow children to play 

with the fixed controls. Keep remote controls out 

of reach of children.

- Do not work near hinges or moving mechanical parts.

- Do not hinder the leaf’s movement and do not 

attempt to open the door manually unless the ac-

tuator has been released with the relevant release 

knob.

- Keep out of range of the motorized door or gate 

while they are moving.

- Keep remote controls or other control devices out 

of reach of children in order to avoid the automated 

system being operated inadvertently.

- The manual release’s activation could result in un-

controlled door movements if there are mechanical 

faults or loss of balance.

- When using roller shutter openers: keep an eye 

on the roller shutter while it is moving and keep 

people away until it has closed completely. Exercise 

care when activating the release, if such a device 

is fitted, as an open shutter could drop quickly in 

the event of wear or breakage.

- The breakage or wear of any mechanical parts of 

the door (operated part), such as cables, springs, 

supports, hinges, guides…, may generate a hazard. 

Have the system checked by qualified, expert per-

sonnel (professional installer) at regular intervals 

according to the instructions issued by the installer 

or manufacturer of the door.

- When cleaning the outside, always cut off mains 

power.

- Keep the photocells’ optics and illuminating in-

dicator devices clean. Check that no branches or 

shrubs interfere with the safety devices.

- Do not use the automated system if it is in need of 

repair. In the event the automated system breaks 

down or malfunctions, cut off mains power to the 

system; do not attempt to repair or perform any 

other work to rectify the fault yourself and instead 

call in qualified, expert personnel (professional 

installer) to perform the necessary repairs or main-

tenance. To allow access, activate the emergency 

release (where fitted).

- If any part of the automated system requires direct 

work of any kind that is not contemplated herein, 

employ the services of qualified, expert personnel 

(professional installer).

- At least once a year, have the automated system, and 

especially all safety devices, checked by qualified, 

expert personnel (professional installer) to make 

sure that it is undamaged and working properly.

- A record must be made of any installation, main-

tenance and repair work and the relevant docu-

mentation kept and made available to the user on 

request.

- Failure to comply with the above may result in 

hazardous situations.

SCRAPPING

Materials must be disposed of in accordance 

with the regulations in force. Do not throw 

away your discarded equipment or used bat-

teries with household waste. You are respon-

sible for taking all your waste electrical and 

electronic equipment to a suitable recycling 

centre.

Anything that is not explicitly provided for in the 

user guide is not allowed. The operator’s proper 

operation can only be guaranteed if the instruc-

tions given herein are complied with. The Firm 

shall not be answerable for damage caused by 

failure to comply with the instructions featured 

herein.

While we will not alter the product’s essential 

features, the Firm reserves the right, at any time, 

to make those changes deemed opportune to 

improve the product from a technical, design or 

commercial point of view, and will not be required 

to update this publication accordingly.