BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
BGS 6743
Brake Disc Puller
INTENDED USE
This tool is used for easy, fast and safe removal of brake discs with a diameter of 170 mm to 400 mm.
The puller reduces vibration impact of wheel bearings, electronic sensors, ball joints, etc..
SAFETY INFORMATIONS
•
Read carefully the instructions before working with this tool.
•
Do not use this tool set for other purpose for which it is designed.
•
Observe the general safety instructions for garages.
•
Keep your work area tidy and clean. Areas or corridors which are untidy increase the risk of
injury.
•
Lifting of vehicles only allowed on the special lifting points.
•
Before starting the work under a vehicle always ensure that it is adequately supported by axle
stands or ramps. Chock wheels and ensure that the hand brake is firmly applied.
•
Always use approved eye protection, especially when working under vehicles.
•
Ensure a secure and well-gripped stance during fitting.
•
Check the condition of the tool regularly and do not use it if it is damaged.
•
Make sure the tool is properly mounted.
•
Do not over tighten the spindle or apply excessive force, as this may damage both the tool and
the component.
•
The tool is not suitable for impact wrenches. The use of an impact wrench can rupture tool parts
and flying tool fragments can cause injury.
•
This manual serves as a brief guide and does not replace a workshop manual. Always refer to
the vehicle-specific service literature, particularly the technical data such as torque values and
instructions for disassembly/assembly, etc.
•
Fetten Sie immer die Schraubengewinde, ehe Sie das Werkzeug verwenden.
•
Keep children and other unauthorized persons away from the work area.
•
Do not let children play with the tool or its packaging and keep this tool out of the reach of
children.
